Search Site


Macerator Pumps: These pumps are an integral part of RV waste systems. They 'chop up' the contents of the RV waste tank, and pump the waste out. We carry Flojet and Jabsco brand macerator pumps, and macerator repair parts.
Circulating Pumps: Circulating pumps are designed to move water at low pressure. They're commonly used in hot water heating systems, and as marine bilge pumps. We carry three different models of Jabsco circulating pumps, for both low- and high-temperature applications.
Water System Pumps: Water pressure pumps are used most commonly in household, RV, or remote cabin water systems. They're usually activated by a pressure switch, which automatically turns on the pump when water system pressure drops below a set PSI. We carry a range of Flojet water pressure pumps, as well as repair parts.
Utility/Transfer Pumps: Utility pumps are often used to transfer fluid from one containter to another. One example would be transferring heating fuel from a transport tank into a home heating system tank. The LVM transfer pumps we carry run on either 12V or 24V DC power, so you can run them off a vehicle battery or battery bank.
Off-Grid Well Pumps: Off-grid pumps are specially designed to run off a renewable energy source (solar or wind power), rather than being activated by a pressure switch or on/off switch. These pumps will operate when power is available, to fill a holding tank. Off-grid pumps are also often used for remote livestock watering stations.

  1. 1
  2. 2
  3. 3
  1. 18550-000

    Flojet 18550-000 Macerator Pump: Hose Barb

    • 12V DC RV waste macerator pump
    • Connects to 3" slip-on RV outlet hose
    • Hose barb discharge port
    • Fresh water rinse capabilities
    • 13 gallons per minute flow rate
    • USCG and CSA listed
    Learn More
  2. 18590-2092

    18590-2092 Jabsco 12V Marine Macerator Pump

    • 12V DC pump, grinds ~12gpm to 1/8"
    • Self-priming: 5ft. lift when wet, 4ft. when dry
    • 1.5in. hose barb inlet, 1in. ID hose barb outlet
    • Can be mounted in any position
    • Designed for permanent installation
    Learn More
  3. 2009-080A

    2009-080A 12V Flojet 4325-143 Replacement Motor

  4. 12VDC replacement motor
  5. Fits following Flojet models:
  6. 4325-143, 2840-100
  7. Learn More
  • 2009-087A

    2009-087A Flojet 4305-144 Replacement Motor

  • 12 volt DC replacement motor
  • Fits following Flojet models:
  • 4305-144
  • Learn More
  • 20406-001A

    Flojet 20406-001A Pump Head, 4406 Series

    • Replacement pump head for Flojet models:
    • 4406-043, 4406-143, 4406-343
    Learn More
  • 20406-008A

    Flojet 20406-008A Pump Head, 4306 Series

    • Replacement pump head for Flojet models:
    • 4306-500, 4306-501
    Learn More
  • 20799-000

    Flojet 20799 1.1 Gal. Water Pressure Accumulator Tank

    • 1.1 gallon accumulator tank
    • Reduces pump cycling and water pressure fluctuations
    • Maximum 100psi working pressure
    • Default pressure: ~20psi
    • Can be adjusted to fine-tune performance
    Learn More
  • 20406-002A

    Flojet 20406-002A Pump Head, 4325 Series

    • Replacement pump head kit
    • Part #7 on exploded diagram (includes parts 1-4)
    • Fits Flojet 4305,4325,2840,2880-series pumps
    Learn More
  • 4406

    Flojet 4406 Quiet Quad 3.3gpm Pump (12V or 120V)

    • 12V or 120V AC water system pump
    • No pressure tank needed!
    • For water systems with up to five fixtures
    • Four chamber diaphragm w/bypass reduces pump cycling
    • Self-priming, can run dry without damage
    • Inlet strainer recommended
    Learn More
  • 4325

    Flojet 4325 4.5gpm Quad Pump (12V, 24V, 120V)

    • Water system pump, 4.5gpm 40psi
    • Available for 12V, 24V, and 120V power systems.
    • For water systems with up to five fixtures
    • Four chamber diaphragm reduces pump cycling
    • Self-priming, can run dry without damage
    • Inlet strainer included
    Learn More
  • Page:
    1. 1
    2. 2
    3. 3

    Back to top